球探网足球即时比分app

Hubei High-altitude Vehicle Leasing Company specializes in high-altitude vehicle rental , ladder rental , and ascending vehicle rental services. Service areas: Jiang'an, Jianghan, Tongkou, Hanyang, Wuchang, Qingshan, Hongshan, Caidian, Jiangxia, Huanghua, Xinzhou, Dongxihu, Hannan et al.

24-hour lift rental hotline: 189-8613-2255
租高空车请点击这里给我发消息 租高空车请点击这里给我发消息

Wuhan lifting platform for rent

Gedian straight arm lift for rent, 8 meters ascending car rental in Ezhou

评论: 0 Author: Xiao Bian Source: Date: 2019-12-31 10:06:03 Popularity: 2 Comments: 0

Gedian straight arm lift for rent, 8 meters ascending car rental in Ezhou Tel: 189-8613-2255

Zhongcheng Equipment Rental Company is a professional high-altitude vehicle rental company. Leased products are: aerial work platforms, self-propelled aerial work platforms, self-propelled aerial work platforms, self-propelled aerial work platforms, self-propelled aerial work platforms, elevator rental

注意事项: 8-meter ascending car rental matters needing attention in Ezhou :

1. The user must be familiar with the road conditions before driving. When driving, do not exceed the allowed side slopes and forward slopes.

2. When on a slope, uneven or soft road, do not raise the work platform or drive with the work platform raised.

3. Before driving on the ground, bridges, trucks and other surfaces, check the load-bearing capacity of these surfaces.

4. Do not exceed the load capacity of the working platform. The load must be evenly distributed on the workbench floor.

5. Unless the lift truck is on a solid, level and flat road, you cannot raise the work platform or drive with the work platform raised.

发电机启动注意事项 Gedian straight arm elevator rental generator start-up precautions

The first start should always be performed at the ground control station. If the engine fails to start normally, do not extend the start time. If the engine fails to start again, let the engine starter "cool down" for 2-3 minutes. After repeated attempts, please refer to the engine maintenance manual. Allow the engine to warm up at low speed for a few minutes before loading any loads. The foot switch must be in the released (upper) position before the starter can run. If the starter is operated with the foot switch in the depressed position, do not operate the straight-arm aerial work vehicle.

Drive forward or backward

1. On the platform console, pull out the emergency stop switch, start the engine, and depress the foot switch.

2. As needed, move the "driving" lever to the "forward" or "backward" position.

timg (2).jpg

    label: