Jintang Electric Lift Rental, Chongyang 8m Lift Platform Rental Tel: 189-8613-2255
Zhongcheng Equipment Leasing Co., Ltd. has a long-term lease of leased and leased aerial platforms, cranes, lifts, etc., and is mainly engaged in the lease of elevator platforms, elevators, and aerial vehicle rental. Daily rent, weekly rent, monthly rent, annual charter are all available and maintained by us, eliminating your worries
不起升： Jintang Electric Lift Can not Rent :
1. The oil level is too low and the oil pump is empty: fill up the hydraulic oil.
2. The down valve is open: When the down button is released, check whether the down valve has power. If there is no power, check the line. If there is no power, then you must replace the down valve.
3. The motor does not rotate: check the motor and circuit.
4, the motor does not turn, there is a buzzing sound: check the circuit breaker and motor wiring.
5. Motor reversal: change two phases of the three-phase line arbitrarily.
6, the voltage is too low: check the starter electricity when the motor load is working.
7, oil absorption filter clogging: clean the filter.
8. When the indicator light is on, press the up button, the motor will rotate and the lifting platform will not rise: check the contact of the three-phase power supply, and the motor will reverse after the power supply is reversed, just correct the power supply.
9. Air leakage in the suction section: clean the filter.
不下降： Chongyang 8m lifting platform lease does not drop:
Generally, there are two reasons that the lifting platform does not descend and the descending valve fails and the descending speed control valve is out of adjustment. In the case of pressing the down button, see if the down valve has power. If there is no power, then the down valve itself is not faulty. That may be a problem with the line. We must check the line. If there is power, then it is down. The valve itself is faulty, so we should clean it or replace it. We can also adjust the descending speed control valve. If the adjustment is invalid, then we need to replace the valve with a new one.