Zengdian scissor aerial work platform rental, Yunmeng 8m vertical elevator rental phone: 189-8613-2255
Zhongcheng Equipment Leasing Company provides high-altitude platform car rental, lifting platform rental, self-propelled elevator rental, etc., operating heights of 8 meters, 10 meters, 12 meters, 20 meters, 24 meters, 28 meters, 33 meters, 36 meters, 38 meters, 45m straight arm, curved arm and scissors, original American JLG
高性价比、产品价格合理，容易被接受、使用后期维护成本低，带来方便、 剪刀车适用于更宽泛的倾角操作、不论室内和室外，两个场地都可以使用,可靠设计、平台和围栏选用全钢材质、轮胎的厚实、耐用性行驶更轻松、安全设计，充电保护器预防被烧毁 Yunmeng 8m vertical elevator rental is cost-effective, the product price is reasonable, easy to accept, low maintenance cost after use, brings convenience, the scissor truck is suitable for a wider tilt operation, both indoor and outdoor, can be used, Reliable design, platform and fence are made of all-steel material, thick tires, durable, easier and safer driving, charging protector to prevent burnout
保养知识: Zengdian scissor aerial work platform rental maintenance knowledge:
1. Check the oil quality and oil level of the hydraulic oil. The lifting platform is raised all the way. In this position, the hydraulic ground should be 40-50 mm higher than the bottom of the box. If it is found that the hydraulic oil is dark, sticky, or foreign matter such as grit, it should be replaced in time (32 # hydraulic oil). The lifting platform year-end maintenance checks all hydraulic pipes and joints. Change the hydraulic oil once after 1000 hours of use, or change it immediately after you notice that the oil has deteriorated. Check the filters of the suction and return pipes in the fuel tank (annual).
2. Engine and battery. Maintenance of power components must also be performed at the same intervals and methods as in automobiles.
3. Tubing, pipes and filters. The pipeline must not be damaged, and the joints must not be loose. All joints must be tightened. Remove and disassemble the lifting platform down valve, blow the plunger with compressed air, install it, and reinstall it. Discard all the hydraulic oil, tighten the joint to take out the oil filter. After cleaning, clean it with compressed air, then put it back into the oil tank and connect the pipeline. (Change to new oil, do not continue to use old oil. Otherwise, moving parts in the hydraulic lifting platform system will accelerate wear and tear.)
4.Are there any wear on the rollers, intermediate shafts and bearings of the aerial platform, cylinder pins and bearings, boom hinges and bearings? Fill some parts with lubricating oil to extend the service life of the lifting platform components.
There is a direct correlation between the stability of aerial work platforms and the complexity of the operating environment of aerial work platforms. In cities, the maintenance of general roads and street lights, the maintenance of wires and cables, and indoor operations are all done by aerial platform operations. These stable operating environments do not greatly affect the stability of aerial platforms. Therefore, in this stable environment, the aerial work platform generally does not appear unstable. If the aerial platform is in a more complex environment, such as in a mountainous or hilly area, the uneven terrain will affect the stability of the aerial platform. Therefore, when working on an aerial work platform, a detailed investigation of the environment on the job site is required to reduce the factors that cause instability when operating on the aerial work platform.